Power Conditioning Module (PCM) with Transient Suppression.

For use with 240v 3Ø, 28 amp max or 240v single phase, 15 amp max. Use on Plasma Block® products up to and including 3500 watts. Variations available 7 - 28 amps to give best power factor match.

Design Features

• Supports 1Ø and 3Ø mains.
• Eliminates transient voltage spikes to DAT210  Inverters and Plasma Block Units
  often caused by contact interruption at full power.
• Includes dc rectification, soft charge, power factor correction (.7 - .94 power factor),
  transient and line noise filtering.  Absorbs transient energy from its specific load – not
  entire large system energy.
• Same mounting dimensions as non-transient products.

Connections

1.) Positive power output to DAT210 board. Connects to “+BUS” 0.25” quick connect tab on circuit board. Minimum of 12 awg wire recommended.

2.) Negative power output to DAT210 board. Connects to “-BUS” 0.25” quick connect tab on circuit board. Minimum of 12 awg wire recommended.

3.) Incoming 3 phase power. 0.25” quick connect tabs.

4.) AC reference signal to DAT210 board. Connect to “INPUT” connector (CON2) on circuit board. Polarity is not critical. Minimum 18 awg recommended.

Connection polarity for 5Vdc to CON3 is critical. Incorrect wiring will damage board!

Wire gauge of 22awg is recommended.

1.)    Pin 1 is for the negative 5Vdc connection. This should be connected to pin 3 on the 16 pin connector on the DAT210
         board  (marked as CON12 on the circuit board).

 2.) Pin 2 is for the positive 5Vdc connection. This should be connected to pin 5
      on   the 16 pin connector on the DAT210 board.